


Screwdriver - Long Flat
Shaft: JÖRG Nr. 1660/1
Ferrule: pin
Tip: "7"
Length: 237mm
Decal: 3 Tone JÖRG decal
Handle: Red with unpainted flutes


Screwdriver - Stubby



Shaft: no marking
Ferrule: no pin
Tip: keystone tip
Length: 100mm (measured 99.71, 99.76, 99.83, 99.86, 100.62, 102.50, 104.22mm)
Decal: 3 Tone JÖRG decal
Handle: Red
Screwdriver - Phillips - early B (Same as Late A Phillips)
Shaft: no marking
Ferrule: crimped, no pin
Tip: phillips tip
Length: 215mm
Decal: no decal
Handle: Red - note how handle is bulbous near the ferrule

Screwdriver - Phillips - late B
Shaft: no marking OR Chrom-Van near tip OR No2 Recess near tip
Ferrule: crimped, no pin
Tip: phillips tip
Length: 220mm ??
Decal: no decal
Handle: Red - note how handle tapers towards ferrule
Screwdriver - Possible Alternate set

This Toolkit came from a 1962 car, and was found in a Blue Tool Bag.
It is unclear if the screwdriver set found in this toolkit belongs to a late 1961 356B or to an early 1962 356B.
Discussion: The Long Flat appeared late 1961. The Philips appeared late 1960. Given these two pieces of information, this is most likely a 1961 kit, that carried over until stock was used up into a 1962 car. The set was complete as seen in the photo below (edited March 6, 2023):

The only item added to this for the photo was a NOS spark plug, otherwise, this is a completely original kit. Click on the image to enlarge. (photo taken in 1/2021)

Screwdriver - Long Flat



Screwdriver - Phillips



Screwdriver - Stubby
